中财网张兆辉演警察的电影:J-Link/J-Trace User's Guide 3 Connectors
来源：百度文库 编辑：中财网 时间：2024/05/04 12:34:01
Connectors
Several target connectors can be installed on the circuit board to access an ARM target system. You can physically plug in units, such as J-Link or J-Trace, to program, debug, and trace hardware systems.
The following units work in JTAG as well as in Serial Wire mode:
- Cortex Debug Connector (10-pins, 0.05")
- Cortex Debug+ETM Connector (20-pins, 0.05")
- ARM Standard JTAG Connector (20-pins, 0.10")
Cortex Debug Connector (10-pins, 0.05")
This 10-pin Cortex Debug connector offers ITM and DWT trace information. Two pins (SWD) are used for debugging, where one bi-directional pin (SWDIO) is used to transfer the information and the second pin (SWDCLK) is used for the clock. A third pin (SWO) delivers the trace data at minimum system cost. The Serial Wire and JTAG pins are shared.
Note
- Pin 7 is keyed and is removed from the connector.
- The 10-pin Samtec FTSH-105-01 connector has the dimensions: 0.25" x 0.188" (6.35mm x 4.78mm).
Cortex Debug+ETM Connector (20-pins, 0.05")
This connector offer debug features, ITM and DWT trace data, as well as ETM instruction trace. ETM signals are output on additional four pins (TRACEDATA). A fifth pin is used for the trace clock (TRACECLK). This way, ETM can be used in either SW or JTAG mode. This connector is a super set of the 10-pin Cortex Debug connector. The first 10 pins on both connectors are identical.
Note
- Pin 7 is keyed and is removed from the connector.
- The 20-pin Samtec FTSH-110-01 connector has the dimensions: 0.50" x 0.188" (12.70mm x 4.78mm).
ARM Standard JTAG Connector (20-pins, 0.10")
This JTAG connector delivers the same functionalities as the 10-pin Cortex Debug connector.
Note
- Dimensions of the ARM JTAG connector are 1.29" x 0.722" (33mm x 18.5mm).