瑞安新城字怎么打:LCM-EX Resin || KOBE STEEL, LTD.

Machinery and Engineering Company
LCM and LCM-EX



Mixing Process Section (LCM-EX)


Pelletizing Mechanism

Extruder (LCM-EX Series)

Extra High Torque Gear Reducer(Patented)
Kobe steel has developed its own extra-high torque gear reducer in order to meet the ever-increasing demand for large polymer production capacity.
VCMT Mixing Technologies (Patented)
Our advanced LCM-EX extrusion technology may also be enhanced using our World renowned 'mixing' technology.
By use of variable clearance mixing segments the following benefits may be achieved when producing certain polymer grades;
- improved dispersive mixing
- lower temperatures
- energy saving
- higher productivity
Gate Control System (OPT)
Adjustment of the circular clearance between the gate and the mixing segment by vertical movement of the gate allows control of the material filling ratio and residence time in the mixing barrel, making it possible to regulate the energy input to the material.
Vent Section
Vent port is used to remove residual monomer, peroxide and transformation products.
In case of large venting requirement, a long vent barrel or several vent barrels are equipped.

Figure of VCMT Mixing Section   VCMT Screw Segment
  
Gear Pump / Screen Changer   Mixing Screw   Vent Section
Screening & Pelletizing Section (LCM-EX)

Mixing Mechanism

Extruder (LCM-EX Series)

Gear Pump (KNT Series) [Option]

Low Energy Consumption
The Kobe design gear pump raises the melt pressure with minimum power consumption and without increasing resin temperature. The gear has high efficiency, good reliability and excellent metering performance.

Dual Type Screen Changer (KSD Series)


Dual Type Screen Changer
Easy Maintenance
Dual passage of the polymer through the twin bars means that screen changing may be done safely at low speed and without interruption to production. Moreover, once the screen pack has been replaced there is no need for cleaning of the breaker plate.
Low Pressure Loss
A split, curved, breaker plate design with a large open-area ratio helps to reduce pressure losses and increase screen-pack life (Patented)
Pelletizer (UP-N Series)

Automatic knife Pressing System
The 'pushing force' of the pelletizer knives against the die-plate is controlled automatically and may be adjusted simply according to polymer type. Thus making it easier to produce pellets of uniform geometry.

Die Plate
utter-Shaft Fixing System (Patented)
A cutter-shaft fixing system, which maintains the cutter-shaft position after setting the knife to the die-plate at an appropriate pressure, helps to reduce knife wear. In addition, the drive system having an extremely low vibration structure stabilized the cutter shaft rotation to provide good cutting quality.
Good alignment of Knives and Die Plate
Drive housing is connected to the front flange of the Water chamber with four tie rods. Cooling water is supplied to the four tie rods so that temperature of the tie rods is kept uniform. The alignment of knives and Die plate is kept at a constant condition, because thermal deformation of water chamber is minimized.
Quick Clamp System
The water chamber and the die-plate can be connected and disconnected by automatic quick-clamps. These allow easy and quick operation during both start-up and maintenance procedures.
Die Plate
Kobe can provide titanium carbide type die plate and tungsten carbide (WC) type die plate. Both of the Kobe developed die plates have excellent wear resistance, and high efficient heating with heat channel.

Cutter Shaft Clamping Mechanism (Patented)
  
Diverter Section   Gear Pump (Option) / Screen Changer   Under Water Pelletizer


Contact us

Back to Top